Table 9. Spacing Between The Roof Supports; Figure 46. Standard Mounting Kit For Portrait Installations; Figure 48. Transverse Profile Mounting To The Roof Brackets; Figure 49. Pv Module Centre Clamps - Baxi Solargen PHOTOVOLTAIC Manual

Figure 46.
Standard Mounting kit for portrait installations
Figure 47.
Standard Mounting Kit + Landscape accesory for Landscape insta-
llations

Figure 48. Transverse profile mounting to the roof brackets

Figure 49. PV module centre clamps

Figure 50. PV modules side clamps

7. SUPPORTING STRUCTURE ASSEMBLING MANUAL
The standard kits are defined to install two PV Panels in portrait position.
(Figure 46)
When a Landscape installation is required needs an additional mounting
kit. The final assembly will use a portrait mounting kit + a Landscape kit
(available as an accessory kit).
The roof supports must be installed according to the distances presented
in the table 9.

Table 9. Spacing between the roof supports

Structure
2 PV Modules Portrait
2 PV Modules Landscape
The transverse profile is mounted to the roof supports using the hammer
head stainless M10 nuts & bolts.
The mounting of the PV modules to the roof profiles is performed with
clamps installed on the sides and in the centres of the modules. These
are fixed using M8 nuts & bolts.
(Figure 47)
Anchors X1 X2 X3
4 1300 - -
8 1300 580 950
(Figure 48)
,
(Figure 49 Figure 50)
Solargen solar PV
Y
800
520
27