Figure 17. Mounting the inverter
communication
Figure 18. Connecting PV strings to the inverter.
3. PV KIT INSTALLATION
3.4.4.
Mounting the inverter
Use of the support provided to install the inverter is recommended. For a
vertical installation, the support should be mounted using 8mm x 50mm
hexagonal head bolts & wall plugs supplied.
1 – Installation with stainless steel hexagonal head bolts and wall plugs;
2 – Mark the three holes for the bolts with the template
3 – Drill the holes and insert the wall plugs;
4 – Install the top screws leaving 4mm protruding from the wall
5 – Hook the inverter with the upper mounting slots on the rear panel, so
as to introduce both splints in the openings at the upper end of the rear
panel.
Visual Inspection: The inverter is properly mounted, only if both splints
are tucked into the rear panel openings.
6 – Fasten the bottom bolt to prevent the removal.
7 – Check the firm mounting of the inverter.
3.4.5.
Connecting PV strings to the inverter.
connection AC
(Figure 17)
(Figure 18)
Solargen solar PV
15