At The End Of A Wash Program; Setting A Delay Start - Baumatic SUPREMA1SS/W User Manual

At the end of a wash program

o The program indicator light will stop blinking and remain on;
there will also be an audible signal that sounds for a period of
time. The LCD display will show the word "END".
o Use the ON/OFF button to switch the dishwasher off.
o IMPORTANT: You should leave the appliance for 15 minutes
BEFORE opening the door. This will allow the steam generated
from the final rinse(s) to dry the dishes.
o Carefully open the door of the appliance and leave it ajar for a
few minutes and allow any remaining steam to disperse.
o WARNING: Hot steam may escape when the door is first
opened, so care should be taken.
o Unload the dishwasher; you should take care in case any of the
items are still warm.
o IMPORTANT: If you leave the door of the dishwasher shut and
do not unload the dishwasher for a prolonged period of time,
then you may get water droplets reforming on the washload.

Setting a delay start

It is possible to delay the start of the wash program for up to a
maximum of 9.5 hours.
o Check whether the appliance needs rinse aid or salt adding to it.
o Pull out the top and bottom baskets, then load them in
accordance with the loading instructions.
o Push the top and bottom baskets fully back into position.
o Add detergent
o Close the door firmly, so that you hear the door lock click shut.
o Turn the appliance on by using the ON/OFF button, the power on
indicator neon will light.
o Use the program selection button, to choose the wash program
that you require. The program indicator neons will light, to show
you which wash program you are selecting.
23