Table of Contents
Advertisement
Let's assume that the following routing is saved as user settings:
DIGITAL OUTPUT 1
DIGITAL OUTPUT 2
Autoswitch
Let's further assume that there is a sync signal on
DIGITAL INPUT 2
Therefore the actual configuration differs from the target configuration (the first output is
automatically switched to the second input).
Status
Auto Switch
1
Answer
<STX> <TYPE> <ADDRH> <ADDRL>
Result:
The status register shows the actual current configuration and the saved user settings.
Command "h": restore user settings
Description: Via this command the
saved in the user settings. This command has impact on:
the connection of
the connection of
the status of a
The
RCS
register about status of auto switch, outputs and inputs.
Example.
The comamnd
Message
<STX> <TYPE> <ADDRH> <ADDRL>
Assumption:The following configuration represent the user settings: sync signal on
DIGITAL INPUT 1
DIGITAL INPUT 1
Status
Auto Switch
0
Acknowledge
<STX> <TYPE> <ADDRH> <ADDRL>
Result:
The user settings are restored, previous made modifications of these connections and
functionalities are re-called.
Restoring configurations is an undo command.
is connected to
is connected to
enabled
.
Out2
Out1
true
true
0
0
m
0
2
tells the
RCM
DIGITAL INPUT 1
DIGITAL INPUT 2
uto switch
executes the command and sends the acknowledge which informs via the status
is sent to the second
h
m
0
2
, no sync signal on
, while auto switch is disabled.
Out2
Out1
true
true
0
0
m
0
2
DIGITAL INPUT 2
DIGITAL INPUT 1
DIGITAL INPUT 1
Reserved Out2
Out1
target
target
0
0
<Body>
<STATH> <STATL <CHKH> <CHKL> <ETX>
q
8
of class m to restore the configuration which is
RCS
:
RCS
<Body>
<STATH> <STATL <CHKH> <CHKL> <ETX>
h
, and both outputs are connected to
DIGITAL INPUT 2
Reserved Out2
Out1
target
target
0
0
<Body>
<STATH> <STATL <CHKH> <CHKL> <ETX>
h
0
, and no sync signal on
Prsnt2 Prsnt1
1
0
1
5
a
d
3
7
Prsnt2 Prsnt1
0
0
1
1
9
8
Advertisement
Table of Contents
