Examining; The Front Panel - Barco Hermes DXD User Manual

3.1 Examin ing
3.1.1 The Fro nt Panel
The front panel of your H
1
REMOTE IN
2
REMOTE OUT
3
LED: DIGITAL IN 1
4
DIGITAL IN 1
5
LED: DIGITAL IN 2
6
DIGITAL IN 2
7
LED: DIGITAL OUT 1
8
DIGITAL OUT 1
9
LED: DIGITAL OUT 2
10
DIGITAL OUT 2
11 LED
: POWER
The socket [1] is for plugging in the remote control cable coming from the previous device
REMOTE IN
(or the controlling PC), the
The socket [4] is for connecting H
DIGITAL IN 1
troller. The DVI cable is plugged in here. If a signal is applied to
else off.
The socket [6] is for connecting H
DIGITAL IN 2
troller. The DVI cable is plugged in here. If a signal is applied to
else off.
The
DIGITAL OUT 1
jection cube. If the signal of
nal of is applied to
DIGITAL IN 2
The
DIGITAL OUT 2
projection cube. If the signal of
signal of
DIGITAL IN 2
The LED [11] indicates the device is switched on and operating properly. If the LED is off,
POWER
H DXD is switched off or the internal logic control has detected an error.
ERMES
DXD looks like this or similar:
ERMES
REMOTE IN REMOTE OUT DIGITAL IN 1
1 2 3
[2] for the cable leading to the next device.
REMOTE OUT
socket [8] is for connecting H
is applied to
DIGITAL IN 1
DIGITAL OUT 1
socket [10] is for connecting H
DIGITAL IN 1
is applied to
DIGITAL OUT 2
DIGITAL IN 2
4 5 6
DXD with the graphic card of a graphical con-
ERMES
DIGITAL IN 1
DXD with the graphic card of a graphical con-
ERMES
DIGITAL IN 2
DXD with the projection unit of a Barco pro-
ERMES
DIGITAL OUT 1
, the LED [7] is orange.
DXD with the projection unit of a Barco
ERMES
is applied to
DIGITAL OUT 2
, the LED [9] is orange.
Hermes DXD
DIGITAL OUT 1 DIGITAL OUT 2
7 8 9 10
Front Panel of Hermes DXD
, the LED [3] is green,
, the LED [5] is orange,
, the LED [7] is green, if the sig-
, the LED [9] is green, if the
Figure 3-1
POWER
11
Figure 3-2