Cabling; Power Supply - Barco Hermes DXD User Manual

3.4 Cabling

This block diagram gives an overview about the cabling of H
The cabling must be done before switching on H
components!
Signal cables are available in different types (fibre or copper), different interfaces
(PanelLink-to-DVI, DVI-to-PanelLink, DVI-to-DVI) and different lenghts. Therefore
they are not included in the delivery of Hermes DXD, but can be ordered according
the actual requirements, please refer to
3.4.1 Power S upply
Check the power rating on your outlet before connecting H
outlet or to a power strip. See section
specification. Contact your facilities manager or a qualified electrician if you are not
sure what type of power is supplied to your building.
H
ERMES
grounded neutral conductor. To reduce the risk of electrical shock, do not plug into
any other type of power system.
Make sure that the main switch is in the off position. Plug in the female end of the power cord into
.
AC In
H DXD offers a power outlet
ERMES
more than one H
ERMES
out of cabling is possible.
AC Out

power supply.

Only Hermes DXD devices are allowed to be plugged into the AC Out of a Hermes
DXD.
DXD is designed to operate with single-phase power systems having a
for connecting another H
AC Out
DXD then up to 10 devices in total may be connected in series. Thus a clear lay-
is connected directly to
DXD
ERMES
ERMES
7.3 Parts List
for the necessary technical
7.1.2 Power Supply
ERMES
and is live as soon as
AC In
cabling Hermes DXD
DXD or any other system
DXD to a wall
ERMES
DXD. When operating
is connected to a
AC In
Figure 3-4