Replacement Instructions
For Use with Kühl
ATTENTION! -
Always unplug the power supply from the power supply receptacle.
Contents:
•
User Interface (UI)
•
Ribbon Cable
•
2 – Mounting screws for UI
•
Instruction Sheet
Step 1.
Disconnect ribbon cable by pulling straight out
Step 2.
Remove 2 –mounting screws securing UI and disconnect ribbon cable
Step 3.
Remove UI and ribbon cable from handle assembly
Step 4.
Install new UI using the 2-screws, route new ribbon cable and reattach ribbon cable to UI
and Main control board
Step 5.
Verify control operation
Ribbon cable connection
(cool only models)
Please read these instructions completely before attempting replacement.
Kühl User Interface Service Kit
and Kühl +
(cool and heat models)
Mounting screws
79