User Interface - Friedrich Q Series Service & Parts Manual

OPERATION

User Interface

All of the control panel function buttons and mode icons can be viewed in Figure 302.
Power On – Press the button to turn on the air conditioner. The power button illuminates to indicate that the power is on. The
backlight on the power switch will automatically turn off after 20 seconds of inactivity. The remote control can also be used to
turn power ON / OFF (see Remote Control).
Display – The display is a high efficiency LCD with a built-in backlight. After 20 seconds of inactivity, the display switches off.
Touching any button automatically changes the display to full brightness.
COOL HEAT FAN ONLY
MODE
Cycles between
COOL, HEAT, FAN
ONLY or -AUTO-
(if equipped)
FAN
Sets fan to either:
- Automatically cycle
- Continuously run
FAN SPEED
Sets fan speed:
LOW, MED, HIGH
15
ON / OFF
Turns unit on/off
-AUTO-
Automatically switches
between cool & heat
Figure 302 (Control Panel and Display)
DISCONNECTED FROM
POWER BOARD
2 DIGIT DISPLAY
Shows Setting for:
- Set Point (Temperature)
- Clock (AM/PM)
CONTROL WI-FI OPERATING
LOCKED STATE
TEMPERATURE
UP
TEMPERATURE
DOWN
TIMER
shows on or off
FILTER
Check / clean