Axis Q7401 User Manual page 9

AMC Audio controls
AMC audio buttons control the speakers and microphone connected to the client computer. The buttons are only visible when
audio is enabled.
Speaker button – Click to switch the sound on or off.
Microphone button – Click to switch the sound on or off.
In Simplex - Network Camera speaker only mode, click this button to stop sending audio to the network camera.
Use the slider to control the volume of the speakers and the microphone.
Half-duplex mode
The Talk/Listen button is used to switch between sending and receiving audio. The button can be config-
ured from the Audio tab in the AMC Control panel:
• Push-To-Talk mode: Click and hold the button to talk/send, release the button to listen.
• Toggle mode: Click once to switch between talking and listening.
Simplex – Network Camera speaker only mode
To send audio, the Talk and Microphone buttons must both be enabled. Click either button to stop audio
transmission.
Pan/Tilt/Zoom controls
When in Center Mode, click on any part of the image other than its exact center and the video encoder will
move so that the point you clicked on becomes the new center of the image.
If you select Emulate Joystick Mode, the video encoder moves in the direction of the mouse pointer. If you
click and hold down on the left mouse button, and then point your cursor at the lower left hand corner of
the image, the video encoder continues to move left and down until you release the mouse button.
AXIS Q7401 - Accessing the Video Encoder
9