Operators Manual
ALS 321/421
3. Labelling
In this chapter you will learn how to install and adjust the labeller. After this step has been com-
pleted, you will be ready to learn how the labeller's parameters can be adjusted to suit your
particular production requirements.
3.1 Threading the Material
Before threading the new material, any old rewound backing material should be removed. Pull
the cone at roller and take the waste paper from the roll. Open the pressure roller and mount
the new label roll. Figure 4 shows the threading for the right hand and the left hand version.
Left hand version
Right hand version
Figure 4 Threading diagram
Release 2/08
Page 13
Labelling