To Connect A Single Aew-R5200 Directly To A Computer's Ethernet Card - Audio Technica ARTIST ELITE 5000 Series Installation And Operation Manual

To connect a single AEW-R5200 directly to a computer's
Ethernet card:
For Windows ®
1. In Windows, open the Network and Dial-up Connections
(or Network Neighborhood for Win 98) window and create a
LAN or High Speed Internet connection to your network card.
2. Under Networking, click on Internet Protocol (TCP/IP) >
Properties.
3. Click on Use the following IP address, and configure the
TCP/IP settings as follows:
• IP address: 10.20.30.* (where * is anything except
"40" because 10.20.30.40 is the receiver's
Ethernet card's default IP address)
• Subnet mask: 255.255.255.0
4. Connect a single AEW-R5200 receiver directly to the
computer's Ethernet card via an RJ-45-terminated crossover
cable. (See Figure D.) Failure to use the proper crossover
cable will prevent the receiver from being recognized by the
software.
5. Power-on the receiver as instructed in Installing and Using
the Software (page 9), and then run the software on your
connected computer.
AEW-R5200
Figure D. Connecting a single AEW-R5200 directly to a computer.
Installing the Hardware
For Macintosh
1. Open System Preferences and click on Network
2. In TCP/IP Tab do the following:
• Configure: Manually
• IP Address: 10.20.30.* (where * is anything except
• Subnet mask: 255.255.255.0
• Router: Leave blank
• DNS Servers: Leave blank
• Search Domains: Leave blank
3. Click Apply now.
4. Connect a single AEW-R5200 receiver directly to the
computer's Ethernet card via an RJ-45-terminated crossover
cable. (See Figure D.) Failure to use the proper crossover
cable will prevent the receiver from being recognized by the
software.
5. Power-on the receiver as instructed in Installing and Using
the Software (page 9), and then run the software on your
connected computer.
RJ-45-terminated crossover cable
(Continued)
®
"40" because 10.20.30.40 is the receiver's
Ethernet card's default address.
Computer
7