To Connect A Single Aew-R5200 Directly To A Computer's Ethernet Card - Audio Technica Artist Elite 5000 Installation And Operation Manual

To connect a single AEW-R5200 directly to a computer's
Ethernet card:
1. In Windows, open the Network and Dial-up Connections
(or Network Neighborhood for Win 98) window and create a
LAN or High Speed Internet connection to your network card.
2. Under Networking , click on Internet Protocol (TCP/IP) >
Properties .
3. Click on Use the following IP address , and configure the
TCP/IP settings as follows:
• IP address: 10.*.*.* (where .*.*.* is anything except
".20.30.40" because 10.20.30.40 is the Ethernet card's
default IP address)
• Subnet mask: 255.0.0.0
AEW-R5200
Figure D. Connecting a single AEW-R5200 directly to a computer.
8
Installing the Hardware
4. Connect a single AEW-R5200 receiver directly to the
computer's Ethernet card via an RJ-45-terminated crossover
cable . (See Figure D.) Failure to use the proper crossover
cable will prevent the receiver from being recognized by the
software.
5. Power the receiver as instructed in Installing and Using the
Software (page 10), and then run the software on your
connected computer.
RJ-45-terminated crossover cable
(Continued)
Computer