To Connect One Or More Aew-R5200 Receivers To An Existing Network To Which Your Computer Is Also Connected; To Connect One Or More Aew-R5200 Receivers Using Dhcp-Supporting Router - Audio Technica ARTIST ELITE 5000 Series Installation And Operation Manual

To connect one or more AEW-R5200 receivers to an existing
network to which your computer is also connected:
(Figure B)
You will need an Ethernet hub and sufficient Ethernet cables to
connect all receivers to the hub, plus one cable to connect the
hub to the network.
1. Check with the network administrator to make certain the
network you are connecting to supports DHCP. If it does not,
ask the network administrator for assistance before
proceeding.
2. Making certain that all hardware is turned off, connect the
hub to your network and to the AEW-R5200(s) by running
RJ-45-terminated cables from the receiver(s) and network to
the hub. (See Figures A and B on page 5.)
3. Power-on the hub, power-on the receivers as instructed in
Installing and Using the Software (page 9), and then
power-on the computer, ensuring that all connections are
live.
4. Run the software on the connected computer. The
AEW-R5200 units will obtain their own IP addresses.
AEW-R5200
AEW-R5200
AEW-R5200
Figure C. Connecting one or more AEW-R5200 units via DHCP-supporting router to a computer (stand-alone network).
6
Installing the Hardware
To connect one or more AEW-R5200 receivers using DHCP-
supporting router (stand-alone network): (Figure C)
You will need an Ethernet router that is configurable as a DHCP
Server, along with sufficient RJ45-terminated Ethernet cables to
connect all receivers to the router and one RJ45-terminated
Ethernet cable to connect the router to the computer.
1. Making certain all of the hardware is turned off, connect the
router to each of the receivers using the RJ45-terminated
Ethernet cables.
2. Connect the computer to an open port on the router using
an RJ45-terminated cable.
Note: Make certain that you do not connect the computer or
any receiver to the WAN port on the router.
3. Power-on the router; Power-on the receivers as instructed in
Installing and Using the Software (page 9); and then
Power-on the computer, ensuring all connections are live.
4. Configure the computer for TCP/IP networking as outlined
below.
For Windows
a. In Windows, open the Network and Dial-up Connections
b. Under Networking, click on Internet Protocol (TCP/IP) >
c. Set TCP/IP settings to Obtain IP address automatically.
For Macintosh
a. Open system preferences and click on Network
b. In TCP/IP Tab, do the following:
c. Click: Apply Now
5. Run the AEWCI software on your connected computer.
RJ-45-terminated cables
DHCP-supporting router
(Continued)
®
(or Network Neighborhood for Windows
and create a LAN or High Speed Internet connection to
your network card.
Properties.
®
Configure: Using DHCP
DNS Servers: Leave blank
Search Domains: Leave blank
DHCP Client ID: Leave blank
The IP Address, Subnet Mask, and Router Fields will fill
with values by the DHCP Server (router connected to
the Mac)
® 98) window
Computer