Navigating The Software; Main System Window; Channel Detail Window - Audio Technica ARTIST ELITE 5000 Series Installation And Operation Manual

Navigating the Software

Main System window

The Main System window shows all of the active (enabled)
receiver channels on the network. A vertical channel "strip"
represents each channel. The window can be resized to view
more channel strips. Alternate views (medium and small) can
be selected by clicking the View menu.
The following is displayed for each channel strip:
• RF level and which True Diversity Tuner is active
• AF (Audio) level and audio overload peak indicator
• Battery Fuel Remaining and Low Battery Condition
• TX and RX Mute status
• Channel Frequency and name
(Selectable TX or RX name per channel)
Double clicking any channel strip opens a "Channel Detail
Window" with additional channel information and user
adjustable parameters.

Channel Detail window

SECTION 1: Monitor RF levels for each antenna. The red
indicators at top show which True Diversity tuner is selected
(which antenna is receiving the stronger signal). RF levels are
grayed out for AEW-R4100 units and for AEW-R5200 units
linked via link cables, because link cables do not transmit
RF-level data.
SECTION 2: Monitor AF level. The red indicator at top lights
when AF level reaches +12 dB (peak audio level). AF level is
grayed out for AEW-R4100 units and for AEW-R5200 units
linked via link cables, because link cables do not transmit
AF-level data.
SECTION 3: Monitor and control the following receiver
functions (see Page 11 for instructions on editing settings):
• Receiver name
• Frequency
• Squelch level
• Display in Main System window channel strip
(transmitter name or receiver name)
• Receiver lock status
SECTION 4: Monitor and/or control the following receiver
features:
• Monitor the status of, and enable or disable, Meter Hold
and Antenna Power (clicking the Off button beside
each function toggles it On).
• Monitor the receiver's IP address and link address
(master or slave).
• Mute the receiver by clicking on the Rx Mute button
(shows up red when system is muted) and monitor the
status of the transmitter (system's failure to unmute when
Mute button is clicked may indicate a transmitter problem).
• Close the window using the Close button.
10
Installing and Using the Software
(Continued)
Figure F. Main System window
SECTION 5: Monitor the following transmitter features:
• Transmitter name
• Transmitter type
• Input type (if handheld, whether condenser or dynamic;
if UniPak ™ , whether mic or instrument)
• Trim setting
• Power level (high or low)
• Transmitter lock status
SECTION 6: Monitor transmitter battery level and mute status.
If the battery level falls below
will light in red.
Note: The low battery indicator on the transmitter and receiver
LCDs does not display until all indicator bars are gone.
1
2
Figure G. Channel Detail window.
1 / power, the Low Batt indicator
4
3
4
5
6