Table of Contents
Advertisement
2.3. INSTALLATION AND USE OF
ACCESSORIES
2.3.1. 7/8" wEAVER MOUNT
optional Weaver mount can be used to install the PS-40 on a MIl-
STD-1913 rail if mounting rail on the rifle has narrow groves (4 mm).
NUT
ClAMP BAr
FIGURE 2-10. ASSEMBLING PS-40 wITH wEAVER MOUNT
1. loosen and remove two screws (M4x8) which secure the Quick
release Mount to the sight body. remove the mount.
2. Put the Weaver mount onto the lug on the sight body. The nuts
of the mount have to be placed on the same side as the switch
knob. Apply a small amount of thread locker on threads, install
two screws (M4x8) and tighten it.
3. loosen the mount nuts and pull the clamp bar back against the
nuts.
4. Place the sight onto the rail surface. Be sure to engage the mount
studs into the grooves on the top mounting surface of the rifle.
The light suppressor should cover the riflescope objective lens.
5. Tighten the nuts using screwdriver.
2-12
WeAver MoUNT
M4X8 SCreW
Advertisement
Table of Contents
