Adapter For A.r.m.s. Mounts; Remote Control - ATN PS-40 Operator's Manual

2.3.2. ADAPTER FOR A.R.M.S. MOUNTS

The PS-40 can be installed on MIl-STD-1913 rail by means of
using an A.r.M.S. #10 or A.r.M.S. #19 ACoG mounts. optional
adapter is used to attach the sight to the said mounts.
1. loosen and remove two screws (M4x8) that secure the Quick
release Mount to the sight body. remove the mount.
2. loosen and remove two screws (M5x8) installed in the adapter.
3. Put the adapter on the sight body. The adapter should not
protrude out beyond the back of the sight body. Apply a small
amount of thread locker on threads, install two screws M4x8
and tighten it.
4. Place the A.r.M.S. mount onto the sight. Apply a small amount of
thread locker on threads, install two screws M5x8 and tighten.
M4X8 SCreW
M5X8 SCreW
FIGURE 2-11. ASSEMBLING PS-40 wITH A.R.M.S. MOUNT

2.3.3. REMOTE CONTROL

remote control is designed to operate the PS-40 in short-time
activation mode.
Attach the remote control to the PS-40 and use it as follows:
1. remove the rubber cap from the connector. The rubber cap
can be placed onto the screw head, that attached the strap of
cap to the body of device (see Figure 2-12 ).
ADAPTer
A.r.M.S.#19 MoUNT
2-13