Table of Contents
Advertisement
P R E PA R I N G T H E D E V I C E
UNPACKING
The following steps must be performed prior to use:
1. Open packaging box, remove ThOR-HD and check the contents.
• ATN Help Card
• ATN Thor-HD
• Battery Lifetime Information and Power Kit Card
• FB Group and ATN Forum Card
• Firmware Update and Review Card
• Black Nylon Case
• Thor HD Manual
• Thor HD Quick Start Guide Card
2. Make sure that nothing is missing.
3. Inspect the device for damage to optical surfaces, body, eyecups, opera-
tion buttons, etc.
4. Ensure that all optical surfaces are clean and ready for use.
NOTE
If any accessories are missing or broken contact ATN's Customer Ser-
vice.
INSTALLATION OF BATTERIES
The Thor-HD will operate on four AA-type Lithium batteries.
NOTE
We highly recommend using lithium AA
batteries. They will provide much longer bat-
tery life. Use only 1.5 V batteries.
Install batteries as follows:
1. Remove the battery cap by unscrewing it
counter clockwise.
2. Insert batteries as shown.
3. Return the battery cap into the housing
socket (screw clockwise until finger tight). Make
sure that the Red O-Ring is not visible to pre-
vent shut off issues due to recoil, but also Do not over-tighten! You want to
ensure you can unscrew the cap next time you replace batteries.
NOTE
Make sure that the device is turned off before changing source of
energy (batteries or USB in power supply mode).
MicroSD, USB
AND HDMI PORTS
The device is equipped with microSD, micro
USB and micro HDMI ports and can be found
under the cap near the battery block (marked
with appropriate icons on the cap).
NOTE
Make sure the device is turned off before
inserting the microSD card into the slot.
7
Hide quick links:
Advertisement
Table of Contents
