Planet NAS-3410 User Manual page 76

There are four steps to take when adding a SmartSync task.
Step 1 is to specify the IP address of the SmartSync server. Please enter the IP address of the
NAS-3410 where you create the sync point. The second input box is for the port number. By
default, port 873 is used to get remote SmartSync server information such as sync point names. If
the port is remapped by a firewall or a NAT device, you must specify the remapped port number
here.
Step 2 is to choose a sync point of "Mirror" mode in the SmartSync server. Please also provide a
user account with the privilege to replicate data to the sync point.
Step 3 is to complete the task settings. On the page you should provide the task name, select the
source folder to replicate, specify the schedule and configure the SmartSync options.
Step 4 is for confirmation, showing the brief information of the task settings.
Making Disk-to-disk Backups
Two or more NAS-3410s are required, one as the SmartSync server, the rest as the SmartSync
clients. It will backup data from the SmartSync clients to the SmartSync server.
On the NAS-3410 which acts as the SmartSync server, create a sync point of "Backup" mode,
which receives data from SmartSync clients and creates data backups in it.
To create a sync point, please go to the Backup SmartSync Server menu on the
Administration Page. Click the Add button to open the page below. On the page you should
provide the sync point name and specify which group is allowed to replicate data to this sync point.
Set the mode to "Backup".
70