Physical Details - Internet Camera - Planet ICA-550W User Manual

Physical Details - Internet Camera

Front - Internet Camera
Lens
Microphone
Power LED
(Green)
Active LED
(Green)
Network LED
(Green)
Rear - Internet Camera
Antenna
Power Input
MIC In
LAN port
Reset Button
No physical adjustment is required or possible for the lens, but you
should ensure that the lens cover remain clean. The image quality is
degraded if the lens cover is dirty or smudged.
The built-in microphone is mounted on the front and center. There is
also a connection for an external microphone on the rear.
Connecting an external microphone will disable the built-in
microphone.
On - Power on.
Off - No power.
Blinking - The Power LED will blink during start up. This will take
15 to 20 seconds.
Off - No user is viewing the camera.
Blinking - User(s) is viewing the camera.
On - Wireless or LAN connection is detected.
Off - Wireless or LAN connection is not detected
Blinking - Data is being transmitted or received via the LAN or
Wireless connection.
Attach the supplied antenna here. The antenna is adjustable; best
results are usually obtained with the antenna positioned vertically.
Connect the supplied 12V power adapter here. Do not use other
power adapters; doing so may damage the camera.
If required, an external microphone can be attached here. Attaching
a microphone here will disable the built-in microphone on the front.
Microphones designed to be used with PCs are usually compatible
with this microphone input.
Use a standard LAN cable to connect your Internet Camera to a
10/100Base-TX hub or switch.
Note:
•
Attaching the LAN cable will disable the Wireless interface.
Only 1 interface can be active at any time.
•
The LAN cable should only be connected or disconnected when
the camera is powered OFF. Attaching or detaching the LAN
cable while the camera is powered on does NOT switch the
interface between wired and wireless.
This button is recessed; you need a pin or paper clip can be used to
depress it. It can be activated at any time the camera is in the
"ready" mode.
•
Restore Default IP Address. When pressed and released, the
4