Setup using the Windows Wizard
Initial setup should be performed using the supplied Windows-based setup Wizard. This
program can locate the Internet Camera even if its IP address is invalid for your network. You
can then configure the Internet Camera with appropriate TCP/IP settings for your LAN.
Subsequent administration can be performed with your Web browser, as explained in Chapter
5 - Web-based Management.
Setup Procedure
1. Insert the supplied CD-ROM into your drive. If the setup program does not start
automatically, run Setup.exe in the root folder.
•
You will see the Welcome screen shown below.
•
Click the Setup Camera button to start the setup Wizard
2. The next screen, shown below, will list all the Internet Cameras on your LAN.
Figure 3: Welcome Screen
Figure 4: Camera List Screen
9