Table of Contents
Advertisement
*1
When the internal temperature is equal to or higher than 60
degree C, the Over Heat LED will light on.
temperature is equal to or higher than 70 degree C, the buzzer
will make a continuous warning sound. Users can press the
buzzer On/Off button to turn off the buzzer.
*2
There are three fans in the unit. Normally, all of the fans are
running. If one of the two running fans at rear panel is failed,
the Fan Failure LED will light on.
2.1.5 GSW-1200S Rear Panel
The rear panel of the GSW-1200S has a Power Connector and two Fans
at the rear of the switch. Besides, a Buzzer ON/OFF button is placed
between. The power port is where you will connect the AC power cord.
(See Figure 2-2 of Rear Panel of GSW-1200S)
Figure 2-2 Rear Panel of GSW-1200S
Power Notice:
1. The device is a power-required device, it means, it will not work till it is
powered. If your networks should active all the time, please consider
using UPS (Uninterrupted Power Supply) for your device. It will
prevent you from network data loss or network downtime.
2. In some area, installing a surge suppression device may also help to
protect your switch from being damaged by unregulated surge or
current to the Switch or the power adapter.
2.2 Installing a GSW-1200S
This section describes how to install your GSW-1200S Gigabit Ethernet
Switch and make connections to the switch. Please read the following
topics and perform the procedures in the order being presented.
PLANET GSW-1200S Gigabit Ethernet Switch do not need software
configuration. To install your GSW-1200S on a desktop or shelf, simply
complete the following steps.
8
Buzzer
ON/OFF
PLANET GSW-1200S
Once the
100-240V AC
50/60 Hz
Advertisement
Table of Contents
