Motion Setup - Planet DVR-1650 User Manual

MOTION SETUP

DVR has built-in video motion detection function. Motion detection area can be selected separately for
each camera. When your DVR detects motions, it begins to record multiplexed video signals from the
camera which motion is detected and display that camera image with up to 30 seconds while selecting
POP-UP DISPLAY
Recoding duration can be selected in MOTION SETUP menu. To access MOTION SETUP, press ENTER
when MOTION SETUP in MAIN MENU using DOWN or UP button is highlighted with blue color. The menu
below will appear on monitor.
1
2
3
4
5
1) SENSITIVITY:
DVR supports 5 sensitivity levels. Higher sensitivity will detection motions easily even there is a brightness
change. It can be selected using LEFT or RIGHT button.
2) FRAME RATE:
The recording frame rate after motion is detected. It can be selected using LEFT or RIGHT button.
3) DURATION:
It defines recording duration after motion is detected. This DVR support 10,30sec,
1,2,3,4,5,6,7,8,9,10,20,30,40,50,60 minutes. It can be selected using LEFT or RIGHT button.
4) CAM NUM: CH1 – CH16
•
AREA SETTING : DISABLE/ ALL/ SETUP
Enable/Disable motion detection; motion zone can be selected separately for each sixteen cameras
using LEFT or RIGHT button.
è On. (Refer to the section DISPLAY SETUPà
MOTION SETUP
SENSITIVITY
FRAME RATE
DURATION
CAM NUM
AREA SETTING
TRIGGER OUT
BUZZER ALERT
5 steps (very low, low, normal, high, very high)
60, 30, 15, 10, 5, 1, 0.5 IPS.(NTSC)
50, 25, 12, 10, 5, 1, 0.5 IPS. (PAL)
: Normal
: 60/ IPS
: 1 MIN
: CH1 – CH16
: DISABLE, ALL, SETUP
: DISABLE, 1 to 4
: DISABLE
)
POP-UP DISPLAY
21