Appendix; Troubleshooting - Pioneer AVIC-N3 Hardware Manual

Appendix

Troubleshooting

➲ About troubleshooting other than description
below ➞ Appendix of the Operation Manual
Symptom
No picture.
The picture is
stretched, the aspect is
incorrect.
Rear display picture
disappears.
Nothing is displayed
and the touch panel
keys cannot use.
Adjusting the volume
of navigation guid-
ance and beep is not
possible.
Playback is not possi-
ble.
LCD Panel knocking
against your vehicle's
console or dashboard.
Video image appears
grainy.
Cause
The parking brake cord is not connected.
The parking brake is not applied.
The aspect setting is incorrect for the dis-
play.
The source disc being listened to with the
navigation system has been ejected.
The REAR/GUIDE button was pressed and
REAR ON mode switched off.
There was a problem with the rear display
or a faulty wiring connection, for example.
Rear View is selected on the screen.
When the shift lever is in [R], displays rear
view camera images. (When "NAVI" is
selected in REAR DISP menu.)
The source without a video is selected.
Operating the PICTURE ADJUSTMENT. There is no picture on the rear display while
The setting for the rear view camera is
incorrect.
The shift lever was placed in [R] when the
rear view camera was not connected.
You cannot adjust them with the VOLUME/
ATT button.
The disc is dirty.
The loaded disc is a type your navigation
system cannot play.
Non compatible video system disc is
loaded.
The loaded disc has a different region num-
ber from the navigation system.
Incorrect setting of angle.
This happens when videos are viewed in
CINEMA or ZOOM mode.
Action (See)
Connect a parking brake cord, and apply the
parking brake.
Connect a parking brake cord, and apply the
parking brake.
Select the appropriate setting for your dis-
play. (➞ "Changing the Wide Screen Mode"
and "Operating the Picture Adjustment" in
the Operation Mannual.)
Before ejecting the disc, switch the source.
This problem may occur when certain con-
nection methods are used.
Press the REAR/GUIDE button to turn
REAR ON mode on.
Check the rear display and its connection.
Select view mode other than Rear View.
Move the shift lever other than turn [R] posi-
tion. (Select "SOURCE" in REAR DISP
menu.)
Switch the source with a video.
the PICTURE ADJUSTMENT is carried
out.
Connect a rear view camera correctly.
Press the NAVI/AV button to return to the
source display and then select the correct
setting for CAMERA.
➲ About CAMERA setting
Manual
• Turn the volume up or down according to
"Volume" in the Setting menu.
• Press the REAR/GUIDE button ond turn
the volume up or down.
Clean disc.
Check what type the disc is. (➞ Page 18)
Change to a disc compatible to your video
system. (➞ Page 18)
Replace the disc with one featuring the
same region number as the navigation sys-
tem. (➞ Page 7)
Press the ANGLE (+/–) button to adjust the
LCD angle. Forcibly adjusting the LCD panel
by hand may damage it.
Select a different mode to view videos.
➞
Operation
17