Chapter 5: Basic Setup Of The Player; Video Setup - Freecom Multimedia Player Manual

Chapter 5: Basic Setup of the player

5.1 Video Setup

The default Video Setup is Composite Connection for general TV. If a general
cable (Yellow) is connected, there is no need to change the settings.
If you want to connect the device by using other cables, select the proper TV
system (NTSC / PAL) for the TV to receive a correct video signal. For Video Setup,
press [Setup] button on the remote control.
When the main screen does not appear
In case, the main screen does not appear after connecting the
proper cables and powering the player on, press [F1] button on
the remote control until you see the main page (Freecom
MediaPlayer-25 Drive-In Kit LOGO PAGE) and then press [Setup]
button in order to match [Video] setup with TV. When necessary
refer to TV manual.
5.1.1 Setup of TV System (NTSC / PAL)
Select [Setup] -> [Video Setup] -> Press [Enter] or [ ] button.
Select [TV Output] by using [
Select a menu by using [ ] and [
Now, the new configuration is applyied. Be sure to press [Enter] button to
save the new setup.
Set other configurations by using arrow buttons or go to other setup pages
by pressing [Setup] button.
Basic Setup of the player
or ] button.
] key and press [Enter] for setup.
GB
5
19