Connecting Power; Universal Ac Power (100-240 Vac); Dc Power - Patton electronics 1082/F User Manual

Important

4.2 CONNECTING POWER

The Model 1082 (all versions) are available with Universal AC (100–
240VAC), 120VAC, 230VAC or -48VDC power options. This section
describes these options.
Universal AC Power (100–240 VAC)
The Model 1082 uses a 5VDC, 2A universal input 100-240VAC, power
supply (center pin is +5V). The universal input power supply has a male
IEC-320 power entry connector. This power supply connects to the
Model 1082 by means of a barrel jack on the rear panel. Many interna-
tional power cords are available for the universal power supply (Refer to
Appendix B, "Model 1082 Factory Replacement Parts and Accessories"
on page 27 for country-specific power cords.
The Model 1082 powers up as soon as it is plugged into an AC outlet—
there is no power switch.The Universal AC supply is equipped with a
male IEC-320

DC Power

The 36-60 VDC DC to DC adapter is supplied with the DC version of the
Model 1082. The black and red leads plug into a DC source (nominal
48VDC) and the barrel power connector plugs into the barrel power sup-
ply jack on the rear panel of the 1082. (See Figure 9).
To Power
Supply Jack
Barrel power connector
Figure 9. Connecting DC power to the 48V-PSM3 DC power supply
Connection of the Patton 1082/F to a CSU DTE requires a
crossover twisted pair cable. Connection of the 1082/F to
a PCM network requires a straight through twisted pair
cable. If you need more assistance with cable selection
and preparation, contact Patton Technical Support at
(301) 975-1007. Additional assistance at our website,
http://www.patton.com, or at our e-mail address at
support@patton.com
18
To -48VDC
Source
-Vin
+Vin
Black lead (-V)
Red lead (+V)