Cable Installation; Installing The Power Cables-Ac Power Supply - Patton electronics 3095 Getting Started Manual

Mdsl digital access and cross-connect system (dacs)

Hide thumbs Also See for 3095:

Table of Contents

Model 3095 mDSL DACS Getting Started Guide

4. Place the DACS at the desired position in the rack.

5. Secure the DACS in position with the mounting screws.

Cable installation

This section describes installing the power, ground, and network interface cables.

Installing the power cables—AC Power Supply

This section describes installing the power cables into the IEC-320 connectors on the DACS. Do not connect

the male end of the power cables to the power outlet at this time. Do the following:

1. Install a power cable into an IEC-320 connector (see ﬁgure 5). The AC main socket outlet shall be within

3 meters of the equipment and shall be easily accessible.

Figure 5. IEC-320 connector and grounding stud locations

To avoid the risk of injury from electric shock, the power cords connected to

the IEC-320 connectors must be grounded power cords.

2 • Hardware installation

Table of Contents