Panasonic KX-T336 Installation Instructions Manual page 174

Description of Assigning Items
Trunk Group
Trunk Name
Direct Termination
Night Answer Point
(Type : No.)
Dial Mode
DTMF Duration Time
Pulse Speed
% break
CPC Detection
Start Arrangement
Wink Signal
Time-Out
Conditions
Before setting this screen, L%roupTrunk
This screen cannot be selected from Trunk-submenu screen, if no CO trunk card is
programmed in 'System-Configuration", Slot Assignment. If any one of the CO trunk
cards is programmed, this screen can be selected.
Technical Manuals Online! - http://www.tech-man.com
Assigns the trunk group number of the CO line.
Assigns the name of the CO line. This will appear on the CRT screen of
the Attendant Console and the display of PITS telephone (if provided)
when making or receiving a CO call.
Assigns the directory number of the destination, when the trunk group of
the line is set to 'DIL 1:l" in Incoming Mode (Day).
Assigns Night Answer point when the 'Incoming Mode (Night)" is assigned
to "FIXED" or "FLEXIBLE."
"NAG" can be selected only when Trunk Group "Incoming Mode (Night)" is
assigned to "FIXED."
If it is not assigned to 'FIXED" nor "FLEXIBLE,"
field, and it is impossible to assign a destination.
Assigns the dial type (DTMF, Pulse or MFC-R2). This is the output mode
regardless of the dial mode of the telephone used.
If Pulse is selected, refer to Section 10-C-51 .OO "World Select 1 (WSl)
about the following items.
Interdigit Pause
l
Pulse Type
l
% Break Detect
l
Assigns the duration of the DTMF tones sent.
It is possible to assign this option only when the "Dial Mode" is set to
'DTMF. When the dial mode is set to 'Pulse," this field is blank.
Assigns the pulse speed.
It is possible to assign this option only when the "Dial Mode" is set to
"Pulse." When the dial mode is set to "DTMF," this field is blank.
Assigns the % break for pulse digits. This is the ratio between on and off
hook signals during digit transmission.
the expected minimum duration for detecting CPC (Calling Party
Control) signal.
Assigns DIDTTIE/E&M start type.
When the trunk group of the line is set to 'DID/TIUE&M", there are two
methods of initiating a call. One is immediate start where the system
outpulses the digits as soon as the trunk is seized and the other is where
the system waits for a signal (wink start) from the far end before any digits
are sent.
Assignable when Start Arrangement is set to "Send Delay Wink."
Group" screen must be programmed.
g-F-3
(70695)