Turning Off Your System; Other Ways To Turn Your System On - DSC Envoy NT9005 User Manual

Turning Off 1. If you are outside, enter through the entry/exit door. The keypad beeps to
Your System
NOTE: Entering by any other door will immediately cause an alarm.
2. Enter your [access code]. If you have entered from outside, you must enter the
NOTE: If you have entered the wrong code the keypad will sound one long
beep - try again to enter the correct code.
3. If an alarm occurred while the system was ON, the NT9005 will display the
CAUTION: If you return and find that an alarm has occurred while you
were away, it is possible that an intruder may still be on the premises. Go to
a nearby safe location, and call your central station or the local authorities
to investigate. The alarm memory is cleared each time the system is turned
on, so any alarms showing have occurred while you were away.
Other Ways to There are two basic methods for turning on your security system.
Turn Your
• Away: Use this method when everyone will be away from the premises. See 9.
System On
• Stay: Use this method when one or more people will stay on the premises. See
You can also use any of the following methods to turn on your system (see pages
10 to 11):
• Quick Arming: Turn on your system without having to enter an access code.
• No Entry Arming: Turn on your system with no entry delay time - use this
• Automatic Arming: The system will turn itself on at pre-set times. Your
8
remind you to turn off the system.
correct access code before the keypad stops beeping. If you do not enter a valid
access code during this time, the system will sound an alarm.
As soon as you enter the correct code, the red (Armed) light turns OFF and the
keypad stops beeping.
Memory icon. See Checking Alarms in Memory on page 14.
10.
Your installer must turn on this feature before it will work.
method when no one else will be entering the premises.
installer must turn on this feature before it will work.