DigiDesign Drawmer Dynamics Owner's Manual page 29

To filter the side-chain input so that only cer-
4
tain frequencies trigger the plug-in, set the LF
Key Filter and HF Key Filter controls to the de-
sired frequency range.
Begin playback. Gating is now controlled by
5
the input or bus you chose as a key input.
Adjust the Noise Gate's Threshold to fine tune
6
side-chain triggering.
Adjust other parameters to achieve the exact
7
effect you want.
Using a Filtered Input Signal for
Side-Chain Processing
To use the filtered input signal to trigger dynamics
processing:
Ensure the Key Input selector is set to No Key
1
Input.
Set the Key section to the Internal setting.
2
Internal
LF Key HF Key
Filter Filter
Side-Chain section
To hear the audio source you have selected to
3
control side-chain input, click Key Listen.
To filter the side-chain input so that only cer-
4
tain frequencies trigger the plug-in, set the LF
Key Filter and HF Key Filter controls to the de-
sired frequency range.
Key
Listen
Begin playback. The plug-in uses the filtered
5
input signal to trigger dynamics processing.
To fine-tune side-chain triggering, adjust the
6
plug-in controls.
Chapter 4: Using Drawmer Dynamics 25