Battery Replacement - Dimplex 20" Compact Owner's Manual

Operation
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call technical
support at 1-888-346-7539.
!
NOTE: the heater may emit
a slight, harmless odor when
first used. This odor is a normal
condition caused by initial heating
of internal heater parts and will
not occur again.
Remote Control
The fireplace is supplied with an
integrated on/off
!
NOTE: Ensure that the
fireplace 3-Position switch
is set to the remote control
setting (up position).
To operate, push the On button
to turn fireplace on, push the Off
button to turn the fireplace
Remote Control Initialization/
Reprogramming
In the event that your remote
control ceases to operate your
fireplace, follow these steps to
re-initialize the remote control and
the receiver in the fireplace:
1. Place the
(Figure 3A) in the Off ("O")
position.
2. Wait a minimum of five (5)
10
(Figure 4)
remote control.
off.
3-Position switch
seconds and then place
the 3-Position switch
Remote Control ("II") position.
3. Within 10 seconds of
changing the switch position,
press the on button located
on the remote control (Figure
4).
this will synchronize the remote
control and the fireplace receiver.
!
NOTE: You will have only 10
seconds to perform this last step.
Failure to do so will result in these
steps needing to be followed
again.

Battery Replacement

to replace the battery:
1. slide battery cover open on
Figure 4
on
Button
OFF
Button
in the
Battery
Battery Cover
www.dimplex.com