NOTE: Procedures and techniques that are considered important enough to emphasize. CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. WARNINg: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire, serious injury, or death. www.dimplex.com...
OPERATION MAINTENANCE Figure 1 WARNINg: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons. NOTE: Even if the fireplace is not used regularly, the battery should be fully recharged at minimum every three (3) months to prolong battery life.
(Figure 3) or ship it to Dimplex North America Limited in the Once battery is out of the opening, remove the two (2) replacement battery packaging material.
Re-assemble the remainder of the fireplace in reverse or ship it to Dimplex North America Limited in the order. replacement battery packaging material. NOTE: Before placing the battery back in the housing/ Ensure the fireplace is turned OFF.
Dimplex North America Limited in the Disconnect the wire lead connectors on the switch replacement battery packaging material.
Page 10
Their positioning on the circuit board to the switch is: (Figure 5) • Red-1, Black-2 goes to the side of the switch farthest from the circuit board, Black-2 on the spade in the cen- ter of the switch and Red-1 on the spade on the right side; www.dimplex.com...
TROUBLESHOOTINg gUIDE PROBLEM CAUSE SOLUTION Appearance Fireplace does not turn On Improper operation Refer to Operation Section Battery not Charged Charge Battery Loose wiring Check wiring connections Dead Battery Replace Battery Defective LED PCB Replace LED PCB Flame Frozen Defective flicker motor Replace flicker motor Loose wiring Check wiring connections...
Need help?
Do you have a question about the TFA36E and is the answer not in the manual?
Questions and answers