Editing Midi Maps - DigiDesign Command|8 Manual

Switches In Stand-Alone mode, 32 of the Com-
mand|8 switches are available in both pages of
each preset.
Programmable switches in Stand-Alone mode
The channel Mute and Solo switches are
premapped to CC 14 (mute) and CC 15 (solo);
Channel Select switches are not premapped.
The Channel View selectors (EQ, Dyn, Insert,
Pan/Send, < > Plug-in Page, Master Bypass, and
Esc) are dedicated (pre-programmed) to CC
121–127 as follows (they retain these assign-
ments even when switching pages or presets,
and can not be changed.
Channel View switch CC assignments
Switch
EQ
Dynamics
Insert
Pan/Send
< Page
Page >
Master Bypass
Esc
46 Command|8 Guide
Programmable
switch rows
CC assignment
121
122
123
124
125
127
toggle Latch/Momen
Name (edit)
Transport Switches The Transport switches are
permanently mapped to standard MMC (MIDI
Machine Control) messages. (The RTZ switch
does not support MMC.)
The following controls are not programmable:
• Encoder mode selectors
• Display Mode
• Modifiers
• Master faders
• Flip
• Bank
• Nudge
• Arrows
• F1–F5
• Stand-Alone
• Control Room switches.

Editing MIDI Maps

This section provides instructions for program-
ming (mapping) Command|8 faders, encoders,
and switches.
Custom mapping can be saved as presets,
and presets can be created, named, and
saved before doing any mapping. See "Pre-
sets to Save and Recall Maps" on page 49.
To enter MIDI Edit mode:
Make sure Command|8 is in Stand-Alone
1
mode.
Press F3 PRE MIDI Recall and select a preset to
2
edit. (See "Selecting Presets" on page 49.)