Fostex D-108 Quick Operation Manual page 7

Assembling the case
<Note>
When you assemble the case, follow the note below:
If a projecting part on the hard disk touches the cover, apply the insulation seal (included in the
package) to the surface of the case where the part would touch. If you use the disk with its part
touching the cover, a short-circuit may occur, leading to a malfunction.
1
.Assemble the case by installing the covers.
After you assemble the case, store the case in a place not subject to magnetic fields. If you remove the
case from the D-108 and store or move the unit, cover the connectors on the removable case with the
dust cover (included in the package) to protect the hard disk from building up static electricity and dust.
Do not touch the connectors with your fingers to avoid static electricity.
Installing the removable case in the D-108
1
. Remove the blank panel that covers the slot for the disk on the front panel of the D-108. (Note: Do not
insert your fingers into the slot when the slot cover is open. Otherwise, electrical shock or injury may
occur.)
2
. Install the removable case (containing a hard disk inside) into the slot.
Push in the case with the correct side facing toward you. (Use both hands to push it in so that the surface
of the case and the front panel become flush.)
3
. Use the included key to lock the removable case.
Connecting a detachable controller
1
. Attach a detachable controller (included) to the hooks on the front panel.
2
. Securely insert the controller's connector cable to the connector on the front panel.
Instead of using the controller, you may use an optional extension cable (Model 8551). Consult your
dealer for more information.
D-108 Quick Operation Guide
7