The D-108 has a slot for an optional hard disk. First you need to install a hard disk into the removable case
included in the D-108 package before you install it into the slot.
The following instructions assume that you have already purchased an E-IDE hard disk unit. Prepare the
following items for hard disk installation:
Removable case
<Note>
Be sure to turn off the power to the D-108 (or remove the power cable from the AC outlet) before
installing a hard disk.
First, you need to disassemble the removable case included in the package so that you can install a hard disk
into it.
Disassembling the removable case
1
.Apply your thumb to the edge of the case on the connector side as shown in the figure, and slightly pull
the cover in the direction of the arrow.
2
.Apply your thumbs to the side of the case and open the cover. In the same manner, open the cover on
the other side. ( Caution: Be careful not to pinch your fingers.)
Using an E-IDE hard disk
Hard disk unit
Installing a hard disk in a removable case
D-108 Quick Operation Guide
Fixing screws
5
Dust cover
Insulation seals
Lock-unlock key