Fostex D-108 Quick Operation Manual page 11

Be sure to install the SCSI terminator.
<Notes on connection>
• Before making connections, make sure that both the D-108 and the SCSI drive are turned off.
• Up to two SCSI drives may be connected on a SCSI chain with the D-108.
Connect one SCSI drive as a "current drive" for real-time recording/playback. (Refer to "SCSI ID
number setting" below.)
Refer to the main Owner's Manual for more information on connecting a SCSI drive as a back-up
drive.
back-up drive
• The SCSI connector on the D-108 is a 25-pin connector compatible with Macintosh computers.
Use a cable with connectors that conform to the standards for connecting a SCSI drive.
• The last SCSI drive on the SCSI chain should be terminated. Install a SCSI terminator, or turn the
termination switch to "on" if the drive has a termination switch (like a Zip drive).
<SCSI ID number setting>
• Be sure to set the SCSI ID number for the SCSI drive correctly, according to the purpose of the drive
(as a current drive or a back-up drive). The ID setting is very important.
Using the SCSI drive as a current drive
Using the SCSI drive as a back-up drive
ANALOG IN
4 3 2
8 7 6
current drive (SCSI ID=any
(ID=6)
number other than "6")
ANALOG OUT MIDI DATA
1 4 3 2 1
INPUT OUTPUT THRU INPUT
5 8 7 6 5
DATA
OPTICAL
THRU INPUT OUTPUT
Select any number from 0 to 5, but not "6."
Select "6."
11
D-108 Quick Operation Guide
SCSI
OPTICAL
AC IN
OUTPUT
Connect the SCSI cable securely.
SCSI
AC IN