Advertisement
Drivers
Low Frequency Driver: 4" Cone Speaker
High Frequency Driver: 5/8" Soft Dome Tweeter
Cabinet Dimensions
144mm (W) x 220mm (H) x 180mm (D) includes heatsink
165mm (D) x cabinet only - no heatsink
5 3/4" (W) x 8 11/16" (H) x 7 1/8" (D) includes heatsink
6 1/2" (D) x cabinet only - no heatsink
Net Weight
3.75 Kg/pc
8Lbs 4oz/pc
Gross Weight (includes all packing material)
9.16 Kg/pair
20Lbs 6oz/pair
Frequency Response
Free-Field Frequency Response : 60Hz to 30kHz
Low Frequency Cutoff : 60Hz (-10dB)
High Frequency Cutoff : 22kHz (-10dB)
Product improvement may warrant a change of specifications, newer materials or cosmetics, Changes in specifications
and features may be made without notice or obligations.
Use high-quality, shielded cables to connect your mixing console, workstation or other source to your
monitors. Foil-shielded cables, such as Belden 8451, 8761, or 9501 should do quite well. Other high
quality cables are available and those that incorporate better shielding will yield an overall higher noise
rejection, lowering your systems susceptibility to exter nal interference. Another important tip to keep in
mind when wiring your system is to route all line level cables away from the AC and other power
sources, this will reduce the probability of having AC hum emanating from your studio monitors.
Prior to cleaning the PM0.4 monitor the power must be disconnected from the PM0.4 monitor.
Once the power has been terminated, cleaning can be accomplished using a damp (not wet) cleaning
rag. A light common household cleaner can also be used, but care must be taken not to use harsh
cleaning fluids. Regular dusting or cleaning with a damp rag will keep your product looking new for years.
p-6
Product Specifications
Cable and Wiring Information
HOT (+)
COLD (-)
SHIELD (
GROUND
Product Cleaning Instructions
Amplifier Power
Low Frequency : 18 W
High Frequency : 18 W
Amplifier Distortion
%
<0.005
THD @ 12 Watts / 4Ohm 20Hz-20kHz
Amplifier Signal to Noise Ratio
>75dB
20Hz - 30kHz Not Weighted
Amplifier Slew Rate
8V/ sec
Power Requirements
US : 120VAC~60Hz
EUR/UK : 230VAC~50/60Hz
Power consumption
US : 40 Watts
EUR/UK : 40 Watts
XLR
TRS
PIN 2
TIP
PIN 3
RING
)
PIN 1
SHIELD
RCA
TIP
SHIELD
Advertisement
