Fortinet FortiGate 50A Installation And Configuration Manual page 204

Configuring PPTP
204
2 Add and configure PPTP users.
For information about adding and configuring users, see
configuring authentication" on page
3 Go to User > User Group.
4 Add and configure PPTP user groups.
For information about adding and configuring user groups, see
groups" on page
To enable PPTP and specify an address range
1 Go to VPN > PPTP > PPTP Range.
2 Select Enable PPTP.
3 Enter the Starting IP and the Ending IP for the PPTP address range.
4 Select the User Group that you added in
5 Select Apply to enable PPTP through the FortiGate unit.
Figure 29: Example PPTP Range configuration
To add a source address
Add a source address for every address in the PPTP address range.
1 Go to Firewall > Address.
2 Select the interface to which PPTP clients connect.
3 Select New to add an address.
4 Enter the Address Name, IP Address, and NetMask for an address in the PPTP
address range.
5 Select OK to save the source address.
6 Repeat for all addresses in the PPTP address range.
172.
177.
"Adding user names and
"To add users and user groups" on page
PPTP and L2TP VPN
"Configuring user
203.
Fortinet Inc.