Adding An Encrypt Policy - Fortinet FortiGate 50A Installation And Configuration Manual

IPSec VPN

Adding an encrypt policy

FortiGate-50A Installation and Configuration Guide
4 Enter the Address Name, IP Address, and NetMask for a single computer or for an
entire subnetwork on an internal interface of the remote VPN peer.
5 Select OK to save the destination address.
To add an encrypt policy
1 Go to Firewall > Policy.
2 Select the Int->Ext policy list.
3 Select New to add a new policy.
4 Set Source to the source address.
5 Set Destination to the destination address.
6 Set Service to control the services allowed over the VPN connection.
You can select ANY to allow all supported services over the VPN connection or select
a specific service or service group to limit the services allowed over the VPN
connection.
7 Set Action to ENCRYPT.
8 Configure the ENCRYPT parameters.
VPN Tunnel Select an Auto Key tunnel for this encrypt policy.
Allow inbound Select Allow inbound to enable inbound users to connect to the source
address.
Allow outbound Select Allow outbound to enable outbound users to connect to the
destination address.
Inbound NAT The FortiGate unit translates the source address of incoming packets to the
IP address of the FortiGate interface connected to the source address
network. Typically, this is an internal interface of the FortiGate unit.
Inbound NAT makes it impossible for local hosts to see the IP addresses of
remote hosts (hosts located on the network behind the remote VPN
gateway).
Outbound NAT The FortiGate unit translates the source address of outgoing packets to the
IP address of the FortiGate interface connected to the destination address
network. Typically, this is an external interface of the FortiGate unit.
Outbound NAT makes it impossible for remote hosts to see the IP
addresses of local hosts (hosts located on the network behind the local VPN
gateway).
If Outbound NAT is implemented, it is subject to these limitations:
Configure Outbound NAT only at one end of the tunnel.
The end that does not implement Outbound NAT requires an internal to
external policy that specifies the remote external interface as the
Destination (usually a public IP address).
The tunnel, and the traffic within the tunnel, can only be initiated at the end
that implements Outbound NAT.
For information about configuring the remaining policy settings, see
policies" on page
9 Select OK to save the encrypt policy.
140.
Configuring encrypt policies
"Adding firewall
195