Table of Contents
Advertisement
Resetting a FortiGate-5001A board
Resetting a FortiGate-5001A board
Installing and removing AMC modules
20
You must eject the FortiGate-5001A board from the chassis slot to cycle the
power and reset the board. See
for information about how to eject a FortiGate-5001A board from a chassis.
This section describes installing a FortiGate AMC Double width Module (ADM) in
the FortiGate-5001A-DW front panel AMC double-width opening or a FortiGate
AMC Single width Module (ASM) in the FortiGate-5001A-SW front panel AMC
single-width opening.
Caution: Do not operate the FortiGate-5001A board with an open AMC opening. For
optimum cooling performance and safety, the AMC opening must contain a slot filler panel
or a FortiGate AMC module.
Caution: Because the FortiGate-5001A board does not support hot swapping AMC
modules, you must eject the FortiGate-5001A board from its chassis slot and completely
open the handles before inserting or removing AMC modules or slot filler panels.
Table 6: FortiGate AMC module LEDs
LED
State
Description
HS
Off
Normal operation.
Blue
Ejection latch open.
Flashing
The module is starting up or shutting down.
OOS
Off
LED currently not in use.
PWR
Amber
The module is properly inserted in the FortiGate unit.
Off
The module is not receiving power from the FortiGate unit.
OT
Off
LED currently not in use.
LINK
Green
The correct cable is in use and the connected equipment has
power.
Off
No link established.
ACT
Flashing
Network activity at this interface.
Green or
Amber
Off
No network activity at this interface.
ACT/RDY Amber
The module is properly inserted in the FortiGate unit.
Off
The module is not receiving power from the FortiGate unit.
PORT
Off
LED currently not in use.
This section describes:
•
Inserting AMC slot filler panels
•
Inserting AMC modules
•
Removing AMC modules
"Removing a FortiGate-5001A board" on page 18
FortiGate-5001A Security System Guide
Hardware installation
01-30000-83456-20081023
Advertisement
Table of Contents
