Amana EXTENDED WALL SLEEVE Installation Instructions
Amana EXTENDED WALL SLEEVE Installation Instructions

Amana EXTENDED WALL SLEEVE Installation Instructions

Ptac extended wall sleeve

Advertisement

READ THESE INSTRUCTIONS THOROUGHLY BEFORE PROCEEDING.
When 230/208 volt units are to be installed, the power
supply may be either cord connected or permanent
wiring. Permanent wiring may be done through the
accessory hard wire junction box, or the accessory
subbase.
When 265 volt units are to be installed, the permanent
wiring must be used for the power supply. Permanent
wiring can be done through the accessory hard wire
junction box, or the accessory subbase. An exposed
cord connection on 265 volt units is not permitted.
The subbase accessory includes leveling legs. If added
wall sleeve support is required and the subbase is not to
be used, an accessory leveling leg kit may be installed.
Kit Accessories .................................................................................................... 2
D
K
....................................................................................................... 2
RAIN
IT
S
, L
UBBASE
Pre-Installation Considerations ................................................................. 3
O
E
UTDOOR
Wall Sleeve Installation .................................................................................. 4
ATTENTION INSTALLING PERSONNEL
As a professional installer you have an obligation to know the product better than the customer. This
Prior to actual installation, thoroughly familiarize yourself with this Instruction Manual. Pay special
attention to all safety warnings. Often during installation or repair it is possible to place yourself in a
Remember, it is your responsibility to install the product safely and to know it well enough to be able to
Safety is a matter of common sense...a matter of thinking before acting. Most dealers have a list of
The precautions listed in this Installation Manual are intended as supplemental to existing practices.
However, if there is a direct conflict between existing practices and the content of this manual, the
Part No. 20491501
Printed in USA
E
XTENDED
I
NSTALLATION
Install before the air conditioner or heat pump chassis is set in place.
L
, M
D
EVELING
EGS
AIN
UCT
P
R
NCLOSURE
ANEL
EMOVAL
RECOGNIZE THIS SYMBOL AS A SAFETY PRECAUTION
includes all safety precautions and related items.
position which is more hazardous than when the unit is in operation.
instruct a customer in its safe use.
specific good safety practices...follow them.
precautions listed here take precedence.
PTAC
W
S
ALL
LEEVE
I
NSTRUCTIONS
Table of Contents
,
H
H
K
AND
YDRONIC
EAT
................................................................. 3
.............................. 2
ITS
September 2004

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EXTENDED WALL SLEEVE and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Amana EXTENDED WALL SLEEVE

  • Page 1 PTAC XTENDED LEEVE NSTALLATION NSTRUCTIONS Install before the air conditioner or heat pump chassis is set in place. READ THESE INSTRUCTIONS THOROUGHLY BEFORE PROCEEDING. When 230/208 volt units are to be installed, the power supply may be either cord connected or permanent wiring.
  • Page 2 KIT ACCESSORIES OUTSIDE RAIN WALL An indoor/outdoor drain kit is available as an accessory item. When a drain kit is to be installed, do so before TOP OF WALL SLEEVE installing the wall sleeve in the wall. See the drain kit for INTERNAL actual installation instructions.
  • Page 3 PRE-INSTALLATION CONSIDERATIONS Before proceeding with the sleeve installation, ensure the following guidelines for locating the wall opening and sleeve are met. WOOD • The wall opening must be the correct size. See FRAME Figure 1 for wall sleeve dimensions and Figure 3 for minimum wall opening size.
  • Page 4 WALL SLEEVE INSTALLATION After the wall opening is checked and approved for loca- Alternative tion, size, and clearances, complete the following to install Fastening Method (Field Supplied) the wall sleeve. 1. Slide the wall sleeve into the wall opening. Do not dis- Wood Screw tort the cabinet shape to fit the wall opening;...

Table of Contents