To Add An Output Sequence; Other Programming Selections - Honeywell XENON 1902 User Manual

To Add an Output Sequence

1. Scan the Enter Sequence symbol (see
Sequence, page 4-25).
2. Code I.D.
On the Symbology Chart
want to apply the output sequence format. Locate the Hex value for
that symbology and scan the 2 digit hex value from the Programming
Chart (inside back cover).
3. Length
Specify what length (up to 9999 characters) of data output will be
acceptable for this symbology. Scan the four digit data length from the
Programming Chart. (Note: 50 characters is entered as 0050. 9999 is
a universal number, indicating all lengths.) When calculating the length,
you must count any programmed prefixes, suffixes, or formatted
characters as part of the length (unless using 9999).
4. Character Match Sequences
On the ASCII Conversion Chart (Code Page
Hex value that represents the character(s) you want to match. Use the
Programming Chart to read the alphanumeric combination that
represents the ASCII characters. (99 is the Universal number,
indicating all characters.)
5. End Output Sequence Editor
Scan F F to enter an Output Sequence for an additional symbology, or
Save to save your entries.

Other Programming Selections

• Discard
This exits without saving any Output Sequence changes.
4 - 22
Require Output
on page A-1, find the symbology to which you
1252), page A-4, find the