SIIG UltraATA 133 PCI RAID Quick Installation Manual page 19

Hide thumbs Also See for UltraATA 133 PCI RAID:

Press Enter to finish driver installation, then follow

the on-screen instructions to complete Windows

installation.

Note: If the Software Installation warning pops up,

click Yes. And if the Hardware Installation warning

pops up, click Yes again. Our driver has been thoroughly

tested for stability and compatibility.

When Windows installation completes, go to Medley

GUI on page 22 and install the RAID monitoring utility

For Existing 32-bit Windows XP /Server 2003 Installation

Setup the RAID array prior to driver installation and

boot up to Windows.

Install the board and boot up in Windows

At the Found New Hardware Wizard:

XP (w/SP1 or earlier)/Server 2003: continue to step #4

XP (w/SP2 or later)/Server 2003 (w/ SP1 or later): select

No, not at this time, then click Next

Insert the driver CD, select Install the software

automatically (Recommended), then click Next.

Note:

automatically after inserting driver CD

If the Windows logo window appears, click

Continue Anyway, then click Finish to complete

the installation. Our driver has been thoroughly tested

for stability and compatibility.

When Windows resumes, go to Medley GUI on page 22

and install the RAID monitoring utility.

Most systems will install the driver

Table of Contents