SIIG UltraATA 133 PCI RAID Quick Installation Manual page 16

11. Follow on-screen instructions to complete setup for
your NT version.
When Windows installation completes, go to Medley
GUI on page 22 and install the RAID monitoring utility.
For An ExistingWindows NT 4.0 Installation
1. Setup the RAID array prior to driver installation and
boot up to Windows NT.
2. Double click My Computer/Control Panel/SCSI
Adapters, then click on the "Drivers" tab.
3. Select Add... then Have Disk....
4. Insert the driver CD, type in D:\32bit (change D: to
match CD-ROM), then click OK.
5. Highlight Silicon Image Sil 0680 Ultra-133 Medley
ATA RAID Controller and click OK.
6. Click Browse , then click drop down arrow in Look
in. Select CD-ROM drive (Drivers), double click
32bit, click Open, then OK.
7. Remove the driver CD, close all open Windows,
then restart NT to complete the installation.
When Windows resumes, go to Medley GUI on page 22
and install the RAID monitoring utility.
To Verify Windows NT 4.0 Installation
1. Go to Start / Settings / Control Panel, double click
SCSI Adapters icon.
2. Highlight Silicon Image Sil 0680 Ultra-133 Medley
ATA RAID Controller from SCSI Adapters listing
and select Properties. A message This device is
working properly is displayed in the dialog box, the
driver has been correctly installed.
16