SIIG UltraATA 133 PCI RAID Quick Installation Manual page 17

Windows 2000
For New Windows 2000 Installation
A new installation of Windows 2000 requires a floppy
disk for the driver installation. To make this floppy disk,
copy the contents of the 32bit folder, found on the driver
CD, onto a blank floppy disk then follow the directions
below.
1. Setup the RAID array prior to Windows installation.
2. Follow Microsoft's Windows 2000 installation
procedure.
3. Restart the computer when prompted.
4. At the Windows 2000 Setup screen, when prompted,
press F6 to install the driver.
5. When prompted press S to specify the location of
the driver.
6. Insert the driver diskette, then press Enter.
7. Silicon Image Ultra-133 Medley ATA RAID
Controller will appear in the box, press Enter.
8. Press Enter to finish driver installation, then follow
the on-screen instructions to complete Windows
2000 installation.
When Windows installation completes, go to Medley
GUI on page 22 and install the RAID monitoring utility.
For An Existing Windows 2000 Installation
1. Setup the RAID array prior to driver installation and
boot up to Windows.
2. At the Found New Hardware Wizard, click Next.
3. Select Search for a suitable driver for my device
(recommended), then click Next.
4. Insert the driver CD,check CD-ROM drives, uncheck
the other boxes, click Next, and click Next again.
17