Vertical Xcelerator Application Note

Network reference time source

Application Note – Network Reference Time Source

Xcelerator IP 07003

This Application Note addresses an issue found with systems that are installed without a

WAN connection to a network reference time source.

When installing the system, a WAN connection MUST be established so that a network

reference time source can be accessed and applied to Xcelerator IP. This connection is

made from the WAN port of Xcelerator IP directly to the internet or via the site LAN with

access to the internet so that Xcelerator IP can establish a connection to a network

reference clock source.

The configuration location for setting network time is found under the Management

section, Internet Time window.

The default for the system primary reference is time.NIST.gov. Additional reference

sources for both the primary and secondary network time reference sources are pre-set

in Xcelerator IP and can be selected from the drop down menus on the user screen, or

you may set your own entry in the primary or secondary reference source boxes.

July 2007

Table of Contents

Need help?

Do you have a question about the Xcelerator and is the answer not in the manual?

Page 1 Xcelerator IP. This connection is made from the WAN port of Xcelerator IP directly to the internet or via the site LAN with access to the internet so that Xcelerator IP can establish a connection to a network reference clock source.
Page 2 Xcelerator IP. Click on Save Settings to apply the reference network time source setting. Failure to set a reference network time source for Xcelerator IP may result in one way speech on inbound calls and system resets.

Xcelerator ip