Table of Contents
Advertisement
A
X
4
B
-
5
3
3
P
l
u
s
A
X
4
B
-
5
3
3
P
l
u
s
devices: "The list will include "Win2000 Promise SATA150 TX2Plus (tm) IDE Controller".
NOTE: If you need to specify any additional devices to be installed, do so at this time. Once all devices are specified, continue
to the next step. If you are using a driver that has not been digitally signed by Microsoft, you will be asked if you want to
continue the installation. Click on Continue anyway.
From the Windows 2000 Setup screen, press the Enter key. Setup will now load all device files and then continue the Windows
2000 installation.
Installing Driver in Existing Windows 2000 System
WARNING: If you will be moving the boot drive containing the existing Windows 2000 operating system to the SATA150
TX2Plus controller, the SATA150 TX2Plus driver MUST be loaded on to this hard drive while it is still attached to your existing
hard drive controller. Do not attach this drive or any other hard drive to the SATA150 TX2Plus controller before completing this
step.
After installing the SATA150 TX2Plus controller and rebooting your system, Windows 2000 setup will show a "Found New
Hardware" dialog box.
Under Windows 2000, "PCI Mass Storage Controller" will be displayed.
1. Choose Add New Hardware Wizard from the list, and then press Enter.
2. Choose Add/Troubleshoot a device and click Next. The new hardware wizard will show device list
3. Choose Mass Storage controller and click Next. At the following screen click Finish.
4. Choose Display a list the known drivers for this device so that I can choose a specific driver then click Next.
83
O
n
l
i
n
e
M
a
n
u
a
l
O
n
l
i
n
e
M
a
n
u
a
l
Advertisement
Table of Contents
