Table of Contents
Advertisement
A
X
4
B
P
r
o
-
5
3
3
A
X
4
B
P
r
o
-
5
3
3
*********************************************************
Installing Drivers During New Windows NT 4.0 Installation
*********************************************************
1. Start system installation by booting from the Windows NT disk:
a. Floppy install: boot the system with Windows NT installation diskettes.
b. Floppyless install: boot from floppy and type "WINNT /B". After files have been copied, the system will reboot. While
rebooting, press "F6" key when the message "Setup is inspecting your computer's hardware configuration..." appears.
c. CD-ROM disk install: boot from CD-ROM disk and press "F6" key when the message "Setup is inspecting your computer's
hardware configuration..." appears.
2. When the "Windows NT Setup" window pops up, press "S" to specify an Additional Device(s).
3. Use "↑" or "↓" to select "Other" and press "Enter" key.
4. Copy all files in "[CD-ROM]:\Driver\Promise\20275" to floppy disk.
5. Place the driver diskette into drive A: and press "Enter" key.
6. Choose "WinNT Promise Ultra133 TX2(tm) Controller" from the list that appears on screen, and then press the "Enter" key.
7. The Windows NT Setup screen will appear again saying, "Setup will load support for the following mass storage devices:"
The list will include "WinNT Promise Ultra133(tm) IDE Controller".
NOTE: If you need to specify any additional devices to be installed, do so at this time. Once all devices are specified, proceed
to next step.
8. From Windows NT Setup screen, press Enter key. Setup will now load all device files and then continues the Windows NT
installation.
9. After installation succeeds, the "SCSI Adapter Setup" box will show saying "WinNT Promise Ultra133 TX2(tm) IDE Controller"
driver has been installed.
83
O
n
l
i
n
e
M
a
n
u
a
l
O
n
l
i
n
e
M
a
n
u
a
l
Advertisement
Table of Contents
