Table of Contents
Advertisement
A
X
4
B
P
r
o
-
5
3
3
A
X
4
B
P
r
o
-
5
3
3
******************************************************
Installing Driver During New Windows 2000 Installation
******************************************************
1. Start the installation:
a. Floppy Install: Boot the computer with Windows 2000 installation diskettes.
b. Floppyless Install: Boot from floppy and type "WINNT". After files have been copied, the system will reboot. While
rebooting, press <F6> after the message "Setup is inspecting your computer's hardware configuration..." appears.
c. CD-ROM Install: Boot from CD-ROM. Press <F6> after the message "Press F6 if you need to install third party SCSI or
RAID driver" appears.
2. When the "Windows 2000 Setup" window pops up, press "S" to Specify an Additional Device(s).
3. Copy all directories and files in "[CD-ROM]:\Driver\Promise\20275" to floppy disk.
4. Place Promise Technology driver diskette into drive A: and press "Enter" key.
5. Use "↑" or "↓" to choose "Win2000 Promise Ultra133 TX2(tm) Controller" from the list that appears on screen, and press
"Enter" key.
6. Windows 2000 Setup screen will appear again saying "Setup will load support for the following mass storage devices:" The
list will include "Win2000 Promise Ultra133 TX2(tm) IDE Controller".
NOTE: If you need to specify any additional devices to be installed, do so at this time. Once all devices are specified, proceed to
next step.
7. From Windows 2000 Setup screen, press Enter key. Setup will now load all device files and then continues the Windows
2000 installation.
81
O
n
l
i
n
e
M
a
n
u
a
l
O
n
l
i
n
e
M
a
n
u
a
l
Advertisement
Table of Contents
