Keypad Interface - Call Notification; Keypad Interface - Call-In-Progress - AMX Design XPress Instruction Manual

For netlinx studio

Hide thumbs Also See for Design XPress:

Table of Contents

Keypad Interface

Keypad Interface - Call Notification

When an intercom zone is called or paged by another zone, the keypad automatically switches to

the Intercom Call Notification page (FIG. 59). Any audio currently playing in the zone is cut-off,

and the caller's microphone is routed to this audio zone. The callee can now hear the caller through

the audio zone speakers. At this point there is nothing more than a one-way connection.

The called zone must accept the call to make a two-way connection. To accept the call, press the

Menu Bar button. When this is done the microphone goes active, each user can hear the other, and

the keypad switches to the Intercom Call-In-Progress page (FIG. 60).

Menu Bar button

FIG. 59 Keypad Interface - Call Notification Page

This page is displayed on the caller's keypad when calling another zone and on the called keypad

when the call has been accepted. The first line of the page shows the zone which is connected to the

call (i.e. the intercom zone of the other keypad). The second line is always blank.

The third line allows you to enter the Intercom Call Settings page (FIG. 62) for intercom zone

configuration. The next two lines are for volume control. The last line is the timeout setting.

Menu Bar button

FIG. 60 Keypad Interface - Call-In-Progress Page

Design XPress User Interface Guide

Table of Contents