Environment Page; Keypad Interface - Cool/Heat Set Point Pages - AMX Design XPress Instruction Manual

For netlinx studio

Hide thumbs Also See for Design XPress:

Table of Contents

Keypad Interface

The Lighting page does not provide feedback for currently active scenes.

Environment Page

The Environment page on the DMS (FIG. 35) allows you to view the current inside and outside

temperatures as well as the heat and cool set points. If the keypad is in an HVAC zone the inside

temperature reported is the temperature reported by the HVAC zone. If an outdoor temperature

sensor is configured in the system that temperature will also be reported. Selecting either the COOL

or HEAT set point buttons will switch to the respective page (Cool/Heat Set Point Page) for

adjusting those set point values.

FIG. 35 Keypad Interface - Environment Page

The Cool and Heat Set Point pages (FIG. 36) allow you to control the set point value. The UP and

DOWN arrow buttons are used to adjust the temperature set point value. The top line of the display

shows which set point is being adjusted. This screen may seem confusing at first because the set

point value displayed is the value reported by the HVAC zone. The inside temperature displayed is

the value sensed by the keypad, not the value from the HVAC zone. If an outside temperature sensor

is installed in an HVAC zone, that temperature is also reported. Pressing any of the menu selection

buttons on the keypad switches you back to the Environment page.

It should be noted that changes to the set point take effect immediately. It is a common

misconception to believe that a selection button must be pressed to "set" or "save" the new set point.

This is not true. As the values are adjusted they are automatically stored.

Design XPress User Interface Guide

Table of Contents